The pollen filter (also called a cabin air filter) on the 2013 Nissan Qashqai is one of the most overlooked service items — and one of the easiest to change yourself. No tools required, it takes around five minutes, and a fresh filter makes a noticeable difference to in-car air quality, heating and air conditioning efficiency.
The filter is located behind the passenger side dashboard and is accessed by removing two simple trim panels. On older vehicles that have never had the filter changed, you'll often find it completely clogged — which reduces airflow through the cabin significantly.
Signs Your Pollen Filter Needs Changing
- Reduced airflow from the vents even on full fan speed
- Musty or unpleasant smell when heater or air con is on
- Increased dust or pollen inside the cabin
- Air con seems less effective than usual
- Filter hasn't been changed in over 12 months or 12,000 miles
- No record of filter change in service history
What You'll Need
Step-by-Step Guide
Open the Passenger Door & Locate the Trim Panel
Open the front passenger door and get down into the passenger footwell. On the left hand side of the footwell you'll see a plastic trim panel. This is held on with push clips — no tools needed. Simply grip it and pull it firmly towards you and it will pop free. Set it to one side.
Remove the Filter Access Panel
With the trim panel removed you'll now see a smaller rectangular access panel behind it. This has a small clip at the bottom — press or pull the clip downwards to release it, then put your finger behind the panel and pull it towards you. It's located at the top by a small tab so once the bottom clip releases you can wiggle it downwards and away. This reveals the pollen filter housing directly above.
Remove the Old Pollen Filter
You can now see the pollen filter sitting in its housing above. Get your fingers in and start to pull the filter out — you'll notice there is a wiring loom and a sensor plug running across the top of the filter housing. Be careful not to snag or break the sensor as you pull the filter out. Work the filter underneath the wiring carefully, pulling it out at an angle. On a neglected vehicle the filter will likely be very dirty — have your hoover ready.
Check the Airflow Direction on the New Filter
Before fitting the new filter, look for the airflow direction arrow printed on the side of the filter. On most vehicles air flows into the cabin from the front of the car, so the arrow should point inward (towards the back of the car). Check the arrow direction on the old filter too — assuming it was fitted correctly — to confirm orientation before inserting the new one.
Fit the New Filter
Slide the new pollen filter into position, feeding it carefully underneath the wiring loom just as you did during removal. Be gentle around the sensor. Once the filter is in the correct orientation, push it fully into the housing — it will spring into place and locate correctly at both the top and bottom of the housing.
Refit Both Panels & Hoover Up
Slide the access panel back up into position, locating the tab at the top first, then pushing the bottom clip back in until it clicks. Then refit the larger footwell trim panel by lining it up and pressing it firmly back onto its clips. Finally hoover up any debris or dust that fell out of the old filter during removal — your customer will appreciate a clean footwell!
🛒 Parts & Tools for This Job
ⓘ As an Amazon Associate, Mr Auto Fixer earns from qualifying purchases. Prices and availability may vary.
🛒 Parts & Tools for This Job
Links below go to Amazon UK. As an Amazon Associate Mr Auto Fixer earns a small commission at no extra cost to you.
Always check part fitment for your specific vehicle before ordering.
Job Summary
What to expect on this job: